DELL POWERCONNECT 3348 MANUAL PDF

Dell™ PowerConnect™ / is provided with pre-defined not set to auto -negotiation, both the switching port and the NIC must be manually set with the. Office Manuals and free pdf instructions. Find the office and computer equipment manual you need at ManualsOnline. Dell Switch User Manual. Page 1. Manufacturer: Dell, Model: , Type of document: User manual, Category: Switch, Number of pages:

Author: Tojar Met
Country: Botswana
Language: English (Spanish)
Genre: Politics
Published (Last): 4 January 2017
Pages: 296
PDF File Size: 16.73 Mb
ePub File Size: 5.27 Mb
ISBN: 397-9-65103-767-8
Downloads: 94653
Price: Free* [*Free Regsitration Required]
Uploader: Kigashicage

Check the Remove check box. To return to device default settings use delete startup-config command at the privileged mode promptand reboot the device.

DELL POWERCONNECT USER MANUAL Pdf Download.

Contents 3 Contents 1 Over view System Description. Configuring An Initial Https Password Open the LAG Configuration page. Global Configuration Mode Global Configuration commands apply to system features, rather than a specific protocol or interface.

Auto-negotiation is performed completely within the physical layers during link initiation, without any additional overhead to either the MAC or higher protocol layers. However the predefined values cannot be deleted. Device Default Settings Jan Port Aggregation multiplies the bandwidth between the devices, increases port flexibility, and provides link redundancy.

Contact Dell technical support before using this option. The Counter Summary page opens: Defining Communities The system powerconbect manages access rights read and write, read only, and so on.

  ANDRAGOGIA DEFINICION PDF

Configuring the PowerConnect / Switch: Dell PowerConnect / User’s Guide

Defining Stp Lag Settings Passwords are limit to maximum of 16 characters. The Interface Statistics page contains the following fields: This section provides information for defining and configuring Quality of Service QoS parameters.

Configuring Address Tables MAC addresses are dynamically learned as packets from sources arrive at the switch. To configure a default gateway, enter the command at the system prompt as shown in this configuration example:.

Dell 3348 manual

Rell is enabled on the port, parameters are defined, and the device is updated. Page 83 Ensure that an IP address is assigned to at least one port on the Master unit.

Select an Event Table powerconnech in the Event Index field. The storm control port parameters are saved to the device. L2 Multicast service is based on a L2 switch receiving a single packet addressed to a specific multicast addresses.

Dell 3348 Switch User Manual

Defining Port Parameters The Port Configuration page allows network administrators to define powerconnevt parameters. The rules should oblige the seller to give the purchaser an operating instrucion of Dellalong with an item.

During initial configuration, it is recommended to configure the device according to the network administrator requirements, in accordance with using an SNMP-based management station.

Reactivates an interface that is shutdown due to port security reasons.

  ALCOTEST 6810 PDF

The Spanning Tree page opens. Configuring An Initial Ssh Password Not all fields [ This command will restart the whole system and disconnect your current session. To verify the IP address, see the following display example.

From the Startup Menu, additional device configuration functions are performed. Open the Access Profiles page. Defining Igmp Snooping Settings Using The Cli To open the Active Images page: The IP Interface Table page opens.

Page The possible field values are: T elnet sessions are assig ned an A uth[ The Image file is selected. Device Rack Installation To open the Versions page: Adding Bridge Multicast Group Members Enter the command interface ethernet at the console to enter the Device Configuration screen mode through VLAN1 as follows: Page Hubs and switches are deliberately wired the opposite way end stations are wired, so that when a hub or switch is connected to an end station, a straight through Ethernet cable can be used, and the pairs match up properly.

Configuration Overview This section describes the initial device configuration and includes: Defining Authentication Profiles Defining Snmp Settings